7.2 Removing and installing roof end strip
Removing
– Open rear lid.
– Remove D-pillar trims ⇒ page 240 .
– Pull roof end strip -1- downwards out of mountings in roof cross
member -4- and out of rear lid seal beading -2-.
Installing
Install in reverse order of removal, observing the following:
– Before installing, check retaining clips -3- for damage and re‐
new if necessary.
– After installation, make sure that the roof end strip -1- is loca‐
ted completely in rear lid seal beading -2-.
Transporter 2016 ➤
General body repairs, interior - Edition 03.2020
7. Roof trims 279
To Next Page
Loading...
Need help?
General