Removing
Note
Removal and installation is described for the front passenger side. Follow same instructions for the driver side
as appropriate.
– Remove grab handle on B-pillar.
– Remove upper B-pillar trim on sliding door side ⇒ page 231 .
– If fitted, remove interior monitoring deactivation switch ⇒ Elec‐
trical system; Rep. gr. 96 ; Anti-theft alarm system; Assembly
overview - interior monitoring .
– Starting at top, pull trim -2- out of mountings and door seal
beading.
Installing
Install in reverse order of removal, observing the following:
Note
♦
Before installing, check all fasteners for damage and renew if
necessary.
♦
Remove any clips -1- left in body mountings using wedge -
T10383- , and fit them in trim for installation.
♦
Following installation, ensure that trim is positioned in door
seal beading.
5.4 Removing and installing C-pillar trim
⇒ “5.4.1 Removing and installing C-pillar trim, Multivan”,
page 237
⇒ “5.4.2 Removing and installing C-pillar trim, Transporter”, page
238
5.4.1 Removing and installing C-pillar trim,
Multivan
Special tools and workshop equipment required
♦ Wedges - T10383-
Note
Removal and installation is described for the front passenger side. Follow same instructions for the driver side
as appropriate.
Transporter 2016 ➤
General body repairs, interior - Edition 03.2020
5. Interior trims 237
To Next Page
Loading...
Need help?
General