Volkswagen Transporter 2016 User Manual

– Remove any adhesive residue on storage compartment.
– Thoroughly clean seat frame in assembly area of all dirt,
grease, wax and other contaminants using adhesive remover.
– Do not apply double-sided adhesive tape on storage compart‐
ment until immediately prior to installing.
Note
The part numbers of the double-sided adhesive tape can be found
in the ⇒ Electronic parts catalogue (ETKA) .
– Do not touch adhesive surfaces once backing film has been
removed.
2.12 Removing and installing lumbar support
adjustment unit
⇒ “2.12.1 Removing and installing lumbar support adjustment
unit, adjusting knob”, page 331
⇒ “2.12.2 Removing and installing lumbar support adjustment
unit, Bowden cable”, page 332
⇒ “2.12.3 Removing and installing lumbar support adjustment
unit, support frame”, page 332
2.12.1 Removing and installing lumbar support
adjustment unit, adjusting knob
Removing
– Pull off lumbar support adjustment knob -1- in direction of
-arrow-.
Installing
Install in reverse order of removal, observing the following:
– Make sure that teeth on lumbar support adjusting knob -1-
align with shaft splines.
Transporter 2016 ➤
General body repairs, interior - Edition 03.2020
2. Front seats 331

Volkswagen Transporter 2016 Specifications

General

Brand	Volkswagen
Model	Transporter 2016
Category	Heater
Language	English