– Pin -4- must be locked in place in backrest frame -2- before
belt end fitting -1- is attached.
Note
♦
The bolt -3- is micro-encapsulated and must be renewed each
time it is removed.
♦
Before a new bolt is installed, the thread of the nut must be
cleaned and chased as necessary.
Install in reverse order of removal, observing the following:
Specified torques
Component Specified torque
Bolt for belt guide 8 Nm
Bolt for belt end fitting 45 Nm
Nut for belt inertia reel 40 Nm
4.15 Removing and installing belt buckle
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1331-
Note
Removal and installation is described for the belt buckle on left
seat. Removal and installation of belt buckle on right seat is car‐
ried out accordingly.
Transporter 2016 ➤
General body repairs, interior - Edition 03.2020
430 Rep. gr.72 - Seat frames
To Next Page
Loading...
Need help?
General