– Roll cover off backrest padding until the lower tensioning wires
are accessible.
– Detach tensioning wire -2- of cover at all lower attachments
from wire frame of padding.
– Detach tensioning wires -1- and -2- of cover at all upper at‐
tachments from wire frame of padding.
– Remove cover and padding from backrest frame.
Installing
Install in reverse order of removal, observing the following:
Specified torques
Component Specified torque
Bolts for cap 3.5 Nm
2.2.10 Separating cover and padding, Trans‐
porter, backrest cover, 3-seater bench
seat
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1783-
Transporter 2016 ➤
General body repairs, interior - Edition 03.2020
2. Rear seat covers and padding 507
To Next Page
Loading...
Need help?
General