Wacker Neuson 28Z3 User Manual

5-10 OM 28Z3 US – Edition 2.0 * * 28Z3b510.fm
Maintenance
Checking the coolant level
☞ Proceed as follows:
• Park the machine on level ground.
• Stop the engine.
• Fold the control lever base up.
• Remove the key and carry it with you.
• Let the engine and the coolant cool down.
• Open the engine cover.
• Check the coolant level on the transparent coolant tank A and on the radiator B.
☞ If the coolant level is below the LOW seam or if there is no coolant at the radiator's
filler inlet:
➥ Fill up coolant.
Important!
Check the coolant level once a day. Check it before starting the engine.
Filling up coolant
After the engine has cooled down:
☞ Release overpressure in the radiator.
☞ Carefully open the cap to the first notch and fully release the pressure.
☞ Open filler cap B.
☞ Add coolant up to the lower edge of the filler inlet (radiator).
☞ Close filler cap B.
☞ Start the engine and let it warm up for about 5 – 10 minutes.
☞ Stop the engine.
☞ Remove the key and carry it with you.
☞ Let the engine cool down.
☞ Check the coolant level again.
➥ The coolant level must be between the LOW and FULL tank seams.
☞ If necessary, add coolant and repeat the procedure until the coolant level remains con-
stant.
Important!
Check the antifreeze every year before the cold season sets in.
Fig. 118: Radiator
FULL
LOW
Expansion tank for coolant
A
B

Wacker Neuson 28Z3 Specifications

General

Brand	Wacker Neuson
Model	28Z3
Category	Excavators
Language	English