Foreword
General safety instructions
BA RD24_RD28 en us 06
25
1.08 General safety instructions
Safety instructions The safety instructions are part of the instruction manual. Please make
yourself familiar with these safety instructions prior to working with the
machine.
Regulations and Provisions In addition to this instruction manual, it is also necessary to adhere to all
laws, standards, regulations and provisions applicable in the country of
use and at the building site. The vandalism protection for the lighting is
not permitted by the StVZO (German Road Traffic Licensing Regulations)
and must be removed when travelling on public roads.
Additional information In case you should obtain additional technical and/or safety-relevant
information for the machine, they also must be adhered to and need to be
attached to the instruction manual.
Electrical system During works at the electrical system, the machine must be de-energised
at the battery isolating switch (if available) or by disconnecting the
negative terminal (ground strap) at the battery.
ROPS roll-over protection The machine frame in way of the ROPS mounting may not be distorted,
bent or torn (deformed). The reinforcement elements of the cabin / roll-
over bar must not show rust, damage, fissures or open fractures. All
screwed connections of the reinforcement elements must comply with
the given specifications and must be screwed tightly to each other.
Observe starting torque values! Bolts and nuts must not be damaged,
bent or deformed. It is absolutely forbidden to modify or repair / level the
reinforcement elements in any way (see page 149 sqq.).
To Next Page
Loading...
Need help?
General
