Operation
Track offset
88
BA RD24_RD28 en us 06
3.10 Track offset
General Compacting work along kerbs or similar borders cannot be carried out,
or only in a limited way, without track movement of the drums. A track
adjustment especially developed for this problem enables the machine to
drive very precisely along such problem areas.
Adjust track movement
WARNING
Unintentional movement!
Risk of injury due to unintentional movement during adjustment works.
■
Put machine on a safe surface (even, capable of bearing,
horizontal).
■
Secure machine against rolling away.
002-42
1. Switch off diesel engine and remove ignition key.
2. Loosen the hexagon nuts [A] of the clamp connection at maximum by
two turns (6x).
3. The track is offset to the left or right by shifting the console with a
suitable tool (e.g. squared timber).
4. Tighten the hexagon nuts [A] (starting torque see page 128 sqq.).
To Next Page
Loading...
Need help?
General
