Xerox 4595 System Administration Guide

Xerox 4595 Copier/Printer System Administration Guide
5-17
5. Using the Scan Service
Enabling the ports and setting the IP addresses
In order to use FTP service on the machine, enable the port and
set the IP address.The procedure for setting the machine is as
follows.
NOTE: The configuration can also be performed using
CentreWare Internet Services.
Refer to “Using CentreWare Internet Services” on page 3-1.
1. Display the System Administrator Menu screen.
a. Press the Log In/Out button.
b. Enter the UserID using the numeric keypad and then
select Confirm.
NOTE:The default User ID value is 11111. When using the
Authentication feature, a password is required. The default
password is x-admin.
c. Select System Settings.
2. Enable the SNMP port.
a. Select System Settings.
b. Select Network Settings.
c. Select Port Settings.
d. Select SNMP and then select Change Settings.
e. Select SNMP - Port and select Change Settings.
f. Select Enable and then select Save.
g. Select Close.
3. Enable the FTP client port and Internet service (HTTP) port as
above.
4. Select Close.

Xerox 4595 Specifications

General

Brand	Xerox
Model	4595
Category	Copier
Language	English