Xerox 4595 System Administration Guide

Xerox 4595 Copier/Printer System Administration Guide
5-24
5. Using the Scan Service
Configuration of the Job Flow
This section describes the configuration procedure to use the job
flow scan function on the machine.
The following is the procedure to use the job flow scan function:
• Enabling the port and setting TCP/IP
Enable the SOAP port, SNMP port, and Internet service port,
and set IP addresses on the machine.
• Configuring the SNMP port
Configure the transport protocol for the SNMP port using
CentreWare Internet Services.
• Configuring the computer
Enabling the ports and setting the IP addresses
In order to use the job flow service, enable the SOAP port, SNMP
port, and Internet service port, and set IP addresses. The
procedure for setting the machine follows.
NOTE: The configuration can also be performed using
CentreWare Internet Services.
Refer to“Using CentreWare Internet Services” on page 3-1.
1. Display the System Administrator Menu screen.
a. Press the Log In/Out button.
b. Enter the UserID using the numeric keypad and then
select Confirm.
NOTE:The default User ID value is 11111. When using the
Authentication feature, a password is required. The default
password is x-admin.
c. Select System Settings.
2. Enable the SOAP port.
a. Select System Settings.
b. Select Network Settings.
c. Select Port Settings.
d. Select SOAP and then select Change Settings.
e. Select SOAP - Port and select Change Settings.
f. Select Enable and then select Save.
g. Select Close.

Xerox 4595 Specifications

General

Brand	Xerox
Model	4595
Category	Copier
Language	English