Xerox 4595 System Administration Guide

Xerox 4595 Copier/Printer System Administration Guide
8-127
8. Setups
NOTE: Notice that print data exceeding the set memory
capacity is not accepted. In such cases, select Hard Disk or
Off.
• Hard Disk Spool: When selected, the machine will use
spooling. The receiving buffer for spooling uses the hard disk.
Receiving Buffer - IPP
Spool
• Off: When Off is selected, the machine will not use spooling.
While IPP print processing is being carried out for one client,
data cannot be received over the same interface from another
client. Set a value for the dedicated IPP receiving buffer
memory capacity from 64 to 1024 KB, in 32 KB increments.
• Hard Disk: When selected, the machine will use spooling.
The receiving buffer for spooling uses the hard disk.
Receiving Buffer -
EtherTalk
Set the EtherTalk receiving buffer. Set a value from 1024 to 2048
KB, in 32 KB increments.
Receiving Buffer - Port
9100
Set the Port9100 receiving buffer. Set a value from 64 to 1024
KB, in 32 KB increments.
Other Settings
For information about each of the following items, refer to
Overview of features page 1, and also refer to the appropriate
chapter (see the Table of contents) in the PostScript User Guide.
Make settings relating to the paper used in the machine.
1. Select Other Settings.
2. Select the item to be set or changed, and select Change
Settings.
3. Select the item to be changed.
4. Select Save.

Xerox 4595 Specifications

General

Brand	Xerox
Model	4595
Category	Copier
Language	English