General Troubleshooting
Xerox
®
B205 Multifunction Printer
User Guide
194
Printer Makes Unusual Noises
Condensation has Formed Inside the Printer
Moisture can condense inside a printer when the humidity is above 85% or when a cold printer is in a
warm room. Condensation can form in a printer after it has been sitting in a cold room that is heated
quickly.
Paper Curl
If your printed output has more than 20
mm
curl, or wrinkling occurs when printing envelopes, use the
rear exit.
1. Open the rear cover.
2. Leave the rear cover open. Prints will be delivered face up.
Note: The rear cover output can only be used for jobs one
sheet at a time.
Probable Causes Solutions
There is an obstruction or debris inside
the printer.
1. Power off the printer.
2. Remove the obstruction or debris.
Note: If you cannot remove the obstruction or debris, contact a
service representative
Probable Causes Solutions
The printer has been sitting in a cold
room.
• Before operating the printer, allow it to acclimate for several
hours.
• Allow the printer to operate for several hours at room
temperature.
The relative humidity of the room is too
high.
• Reduce the humidity in the room.
• Move the printer to a location where the temperature and
relative humidity are within the operating specifications. For
details, refer to Environmental Specifications.