2-7
Phaser 3635MFP
02-100, 200
Status Indicator RAPs
Draft 4
02-100, 200 USB Faults RAP
02-100 The USB device is invalid. Only SCSI type memory is supported.
02-200 The USB memory is full or there is no response from the USB memory.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Refer to Wiring Diagram 5. Perform the following:
1. Make sure that the customer is using a valid USB device with sufficient free space.
2. Check the wiring between the USB host PWB, PL 3.10 Item 11 and CN7 on the Main
PWB.
3. Install new components as necessary:
• USB harness, PL 3.10 Item 13
• USB host PWB, PL 3.10 Item 11
4. Perform OF7 Main PWB Check RAP.
To Next Page
Loading...
Need help?
General
