2-25
Phaser 3635MFP
08-100, 08-200
Status Indicator RAPs
Draft 4
08-100 Jam 1 RAP
08-100 The lead edge of the document failed to actuate the fuser exit sensor within the correct
time after registration.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Do not touch the fuser while it is hot.
NOTE: The front cover assembly interlock switch must be closed to supply +24V to the motors
and clutches.
Refer to Wiring Diagram 2, Wiring Diagram 8 and Wiring Diagram 9. Perform the following:
1. Switch off the machine, then switch on the machine.
2. Open the front cover assembly, PL 28.10 Item 7. Remove all jammed paper.
3. Remove the print cartridge, PL 9.10 Item 1 and the fuser module, PL 10.10 Item 1. Check
the paper path for damage or obstructions.
4. Open the fuser door, PL 10.12 Item 19. Check the following, install new components as
necessary:
a. The fuser exit sensor actuator, PL 10.12 Item 9 moves freely and is not damaged.
b. The fuser heat roll, PL 10.15 Item 1, pressure roll 1, PL 10.15 Item 2 and pressure
roll 2, PL 10.15 Item 3 are clean and rotate freely.
c. The fuser exit roll, PL 10.12 Item 6 and idlers, PL 10.12 Item 17 are clean and rotate
freely.
d. The fuser stripper fingers, PL 10.12 Item 13.
5. Enter dC330 code 08-600. Check the fuser exit sensor (Q08-600). If necessary, install a
new HVPS, PL 1.10 Item 3.
NOTE: The fuser exit sensor is mounted on the HVPS.
6. Reinstall the fuser. Enter dC330 code 04-200. Check that the exit motor (MOT04-200), PL
10.20 Item 4, runs and drives the fuser rolls.
7. Check the wiring between the exit motor and CN2 on the Connection PWB. Install new
components as necessary, PL 10.20.
8. Enter dC330 code 04-100 to run the main BLDC motor.
9. Check the wiring between the main BLDC motor and CN38 on the Main PWB.
10. If necessary:
a. Install a new print cartridge, PL 9.10 Item 1.
b. Perform OF7 Main PWB Check RAP.
08-200 Jam in Tray RAP
08-200 The machine has detected a paper jam in the tray 2 feed area.
Procedure
Go to the 07-230 Jam 0 from Tray 2 RAP.