124
Configure 802.1X with Internet Services
In addition to enabling 802.1X at the machine, 802.1X can be configured with Internet Services (the
embedded HTTP server running on the device). Make sure that the HTTP and TCP/IP protocols are
properly configured for your network before attempting to use your web browser to communicate with the
machine’s HTTP server.
Note: Some ports in an 802.1X environment may not be open, preventing Internet Services screens from
being displayed. If this is the case, enable and configure 802.1X first at the machine as previously stated
in this section, then use Internet Services to modify settings as required and stated below.
At your Workstation:
1. Open your Web browser and enter the TCP/IP address of the machine in the Address or Location field.
Press [Enter].
2. Click the [Properties] tab.
3. Enter the Administrator User name and password if prompted. The default is [admin] and [1111].
4. Select the [Security] link.
5. Select the [802.1X] link.
6. Select [Enable 802.1X].
7. Select the required [EAP] type.
8. Enter the [Username] and [Password] required by your authentication switch and server.
9. Click [Save].
To Next Page
Loading...
Need help?
General
