199
Install the Fax Hardware Kit
NOTE: If Server Fax is installed on the machine when the Embedded Fax Install Wizard is run, the
Server Fax feature will be disabled and users will only have access to the Embedded Fax feature.
1. Switch the power off by pressing the Power Off button.
2. Wait a couple of minutes for the Network Controller to fully power off. The blinking green network
activity light will be extinguished when this occurs.
3. Install the Fax Hardware Kit following instructions contained with the kit.
4. Connect the telephone cable to the port on the machine.
5. If you have purchased the 2 Line Fax Kit, fit the kit following the instructions contained with the kit.
Once fitted, connect the second telephone cable to the second port on the back of machine.
6. Switch the machine on by pressing the [Power On] button.
To Next Page
Loading...
Need help?
General
