212
Install the Network Accounting feature
When you purchased the Network Accounting Kit, you received the information and SIM required to install
this feature. Following the supplied instructions for full details, with the device powered on, the SIM is
inserted into an orange slot on the machine's backplane. An Options Assist screen pops up to assist with
installation.
To Enable the Network Accounting feature at the Machine
1. Press the [Log In / Out] button to access the Tools pathway.
2. On the keypad enter [admin], then [1111] or the current password. Touch the [Enter] button when
finished.
3. Touch [Machine Status], then from Tools, select Accounting.
4. Select [Accounting Enablement].
5. Select [Accounting Mode].
6. Select Network Accounting and touch Save.
7. The machine may reboot. If it does, the network controller takes approximately 5 minutes to reboot.
To Next Page
Loading...
Need help?
General
