<Paring sealant>
Pare off sealing material on the surface with a
scraper. Do not to scratch or damage on the mating
surface. If the surface gets scratch or damage,
correct them by grinding with oilstone.
<Applying the liquid gasket>
1. Wipe the oil or dirt from the mating surface with
a wiper dipped in cleaning solvent. Oil must be
removed completely.
Do not use kerosene or diesel oil.
2. Cut the applying nozzle as the bead width of
squeezed liquid gasket is 3 to 3.5 mm. Set a
squeezing tool if available.
Do not level the applied liquid gasket with a
finger or a spatula. It may cause incomplete
sealing.
3. When the liquid gasket is supposed to be
applied around a bolt hole, apply it inner side of
the mating surface.
4. Assemble mating surfaces within 15 minutes
after applying liquid gasket.
5. Tighten all bolts lightly and tighten them further
till specified tightening torque is obtained. The
bolts must be tightened diagonally.
6. Wait for more than 30 minutes after assembly to
fill up lubricating oil or operate.
Apply liquid gasket
Within 15 minutes
Assembly
Leave for 30 minutes or longer.
Lubrication, operation
Be sure to follow the specified time or it could
cause leakage.
To Next Page
Loading...
Need help?
General
