Zebra DS6878 Product Reference Guide

Scanner Emulation Interface 12 - 3
Scanner Emulation Parameter Defaults
Table 12-1 lists the defaults for the Scanner Emulation host. To change any option, scan the appropriate bar
code(s) provided in the Scanner Emulation Host Parameters section beginning on page 12-4.
Scanner Emulation Host
Scan the bar code below to enable the Scanner Emulation host.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 12-1 Scanner Emulation Default Parameters
Parameter Default Page Number
Beep Style Beep on Successful Transmit 12-4
Parameter Pass-Through Parameter Process and Pass Through 12-5
Convert Newer Code Types Convert Newer Code Types 12-6
Module Width 20 µs 12-6
Convert All Bar Codes to Code 39 Do Not Convert Bar Codes to Code 39 12-7
Code 39 Full ASCII Conversion Disable 12-7
Transmission Timeout 3 sec 12-8
Ignore Unknown Characters Ignore Unknown Characters 12-9
Leading Margin 2 ms 12-9
Check for Decode LED Check for Decode LED 12-10
1
User selection is required to configure this interface and this is the most common selection.
Undecoded Scanner Emulation Host

Zebra DS6878 Specifications

General

Wavelength	655 nm
Scanner type	2D
Yaw reading angle	-60 - 60 °
Decoding standards	1D, 2D, PDF417, PDF417, microPDF417, Composite Codes (CC-A, CC-B, CC-C), U.S. Postnet and Planet, U.K., Japan, Australian, Netherlands KIX code, Royal Mail 4 State Customer, UPU ICS 4 State Postal, USPS 4CB, TL C-39, Aztec (Standard, Inverse), MaxiCode, DataMatrix/ECC 200 (Standard, Inverse), QR Code (Standard, Inverse and Micro)
Tilt reading angle	-360 - 360 °
Input voltage	5 V
Bluetooth	Yes
Dimensions (WxDxH)	69 x 97 x 185 mm
Certification	FCC, RoHS
Product color	Black
International Protection (IP) code	IP43
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %
Cables included	USB

Weight and Dimensions

Weight	238 g