iv DS6878 Product Reference Guide
Revision History
Changes to the original manual are listed below:
Change Date Description
-01 Rev A 4/2010 Initial release.
-02 Rev A 3/2011 Add: CR0078-P cradle, FIPS configurations, Imaging Preferences chapter,
hands-free scanning instructions, Page Button, Chapter 7: SNAPI Parameters,
Simple COM Port Emulation, Quick Keypad Emulation, Polling Interval, French
Belgian to USB and KBW chapters, GS1 DataBar Limited Security Level, Move
Cursor parameters, PDF417, AZTEC, Micro QR, Micro PDF, Maxicode, Data Matrix,
USPS 4CB and UPU FICS Postal, Appendix G: Signature Capture.
Correct: 5 Secs parameter in Chapter 5: Timeout to Low Power Mode from Auto
Aim, Send Alt 2 and add Send Alt @ parameters in ADF chapter.
Remove: Baud Rates: 600, 1200, 2400, and 4800, Stop Bit Select section.
-03 Rev A 1/2012 Add: French International, Timeout Between Decodes: Different Symbols,
Presentation Mode Field of View, Australia Post Format, USB Convert Unknown to
Code 39, Emulate Keypad with Leading Zero, USB Static CDC.
Update: LED indicator definitions; battery specification; Beeper Tone description;
Beep on Insertion parameter number; Batch Mode parameter number. Add note to
indicate that the default is Enable for HC Configurations and Disable for Non-HC
Configurations for the following parameters: GS1 Databar Limited, Composite A/B,
Composite C, Datamatrix and Beep on Decoding.
Correct: Disable Page Button bar code, Set Pin Code parameter.
Remove: Matrix 2 of 5 Redundancy parameter.