、
62
CHK
ADJ
Fig.2 FRONT FORK
COMPONENT
Light height adjustment
PROCEDURE:
●Light height adjustment
The rider sits in the bike and straightens the bike. Another person inserts a PH2 type Phillips screwdriver
(diameter 6mm) into the hole near the lower link plate of the car, aligns the adjusting bolt, rotates clockwise
to increase, and counterclockwise to decrease the beam height.
CAUTION:
●Light height adjustment should be noted as follows:
Too High or too low light levels can affect safe driving. The height of the lights should be properly adjusted
according to whether there are changes in the weight of the occupants and the driver.
It is forbidden to adjust the light height during riding. It is advisable to adjust the road with a smooth road
surface and a straight line distance of about 150 meters without affecting traffic safety at night.
To Next Page
Loading...
Need help?
General
