COOLING SYSTEM
RS 125
5.6. EXPANSION RESERVOIR
5.6.1. EXPANSION RESERVOIR
TORQUE WRENCH SETTINGS
Expansion reservoir retaining screw (1) 3 Nm (0.3 kgm).
REMOVAL
• Drain the cooling circuit; see
5.2.1.
• Release and remove the screw (1).
• Remove the clip (2).
• Disconnect the tube (3) from the expansion reservoir
(4).
• Remove the expansion reservoir (4).
WARNING
Store the expansion reservoir (4) in a safe
place.
INSTALLATION
• Position the expansion reservoir (4).
NOTE Be sure to have the special clip tweezers (no.
0277295) ready at hand and renew all clips using the same
type fitted originally.
• Refit the tube (3) to the expansion reservoir (4).
• Tighten the screw (1).
• Fill the cooling circuit; see
5.2.1.
5 - 8
To Next Page
Loading...
Need help?
General
