CHASSIS
7 - 81
RS 125
7.8.2. REPLACING THE REAR BRAKE PADS
Read
1.2.1 and 2.12.3 carefully.
• Place the motorcycle on the stand.
• Remove the brake caliper cover (1).
• Release the retaining ring (2).
• Withdraw the pin (3) and collect the clip (4).
• Remove the brake pads (5).
WARNING
Do not operate the brake lever with the brake
pads removed, or the brake caliper pistons
might fall out leading to loss of brake fluid.
• Fit two new brake pads taking care to align the holes
with the caliper holes.
WARNING
The brake pads must always be replaced in
pairs. Ensure they become properly seated in
the brake caliper.
• Position the clip (4) and insert the pin (3).
• Fit the retaining ring (2).
• Refit the caliper cover (1)
• Check brake fluid level; see
2.12.4.
To Next Page
Loading...
Need help?
General
