ROUTINE MAINTENANCE
RS 125
2.4.2. CHECKING AND CLEANING THE TERMINALS
Carefully read 2.4.1.
• Make sure that the ignition switch is in position "
".
• Raise the fuel tank, see 2.9.1.
• Make sure that the cable terminals (1) and the battery
terminals (2) are:
in good conditions (and not corroded or covered with
deposits);
covered with neutral grease or vaseline.
If necessary, proceed as follows:
• Disconnect the negative cable (-) first and the the
positive one (+).
• Brush the wire with a wire brush, in order to eliminate
any trace of corrosion.
• Reconnect the positive terminal (+) first and then the
negative one (-).
• Cover the terminals of the cables and of the battery
with neutral grease or vaseline.
• Refit the fuel tank, see
4.1.1.
2 - 16
To Next Page
Loading...
Need help?
General
