APRILIA RS 125 User Manual

CHASSIS
7 - 64
RS 125
7.5.3. FRONT WHEEL DISASSEMBLY
Read
1.2.1 carefully.
• Remove the front wheel; see
7.5.2.
• Clean both ends of the wheel hub with a cloth.
• Remove the seals (1).
• Remove the drive ring (2).
• Remove the left-hand bearing (3) using a suitable
bearing extractor.
• Remove the right-hand bearing (4) using a suitable
bearing extractor.
4
12
3
5
WARNING
Inspect the bearings after each removal; see
7.5.4. Replace as required.
• Collect the inner spacer (5).
• Clean the wheel hub bore thoroughly.
• Wash all components using clean detergent.
WARNING
Refit the bearings using a drift with the same
diameter as the bearing outer ring.
Do not tap the balls or the inner ring.
Make sure to push the following components
into firm contact with the adjacent parts:
- right-hand bearing (4) with hub;
- spacer (5) with right-hand bearing (4);
- left-hand bearing (3) with spacer (5).

APRILIA RS 125 Specifications

General

Brand	APRILIA
Model	RS 125
Category	Motorcycle
Language	English