CHASSIS
7 - 102
RS 125
7.11.4. REASSEMBLING THE SWINGING ARM
Read
1.2.1 carefully.
NOTE Change both needle roller bearings.
• Clean all components of the swinging arm articulated
connection and apply lithium grease.
• Install two new needle roller bearings (1) using a drift
with adequate diameter. The bearings must be centred
axially in the bearing housing.
• Position the four O-rings (2).
• Slide the two bushes of the needle roller bearings (3)
into the swinging arm.
• Position the outer plastic washers (4).
4
1
1
2
3
2
4
To Next Page
Loading...
Need help?
General
