CHASSIS
7 - 39
RS 125
7.3.2. REMOVING THE THROTTLE CABLE FROM IN-
TERMEDIATE PULLEY TO OIL PUMP
TORQUE WRENCH SETTINGS
Screw (2) 5 Nm (0.5 Kgm)
• Lift the fuel tank, see
2.9.1.
• Remove the left fairing, see
7.1.2.
• Loosen and remove the three screws (1) and remove
oil pump cover.
•
Slide out the throttle cable.
• Loosen and remove screw (2) from frame inner face,
on vehicle left side.
•
Remove throttle cables pulley cover.
• Slide out throttle cable from oil pump.
WARNING
Upon reassembly, adjust throttle cable tension
by turning nut (3) on the oil pump.
To Next Page
Loading...
Need help?
General
