CHASSIS
7 - 54
RS 125
7.4.10. SEAT SUBFRAME REMOVAL
TORQUE WRENCH SETTINGS
Screw (1) 7 Nm (0.7 Kgm)
Screws (2) 22 Nm (2.2 Kgm)
• Remove the voltage regulator; see
7.2.3.
• Remove the seat subframe lower moulded cover; see
7.1.12.
• Remove the airbox; see
4.2.2.
• Remove the oil tank; see
3.1.1.
• Remove both passenger footpeg brackets; see
7.4.7
.
• Remove the seat latch; see
7.4.7.
• Release and remove the screw (1) and collect the nut.
• Move aside the rear brake fluid reservoir.
WARNING
Keep the rear brake fluid reservoir in a vertical
position to avoid spilling brake fluid. Any brake
fluid spills could lead to a dangerous condition.
• Release the seat subframe from all wiring ties.
• Release and remove the two screws (2) working on
both sides of the motorcycle.
• Remove the seat subframe.
To Next Page
Loading...
Need help?
General
