1508685 Rev D Introduction 1-9
■ EMI suppression (required for CENELEC systems)
1
■ SMM debug interface cable (not provided)
■ Computer running terminal-emulation application (Optional–used for SMM
verification. See Table 1.2)
Tools
■ PC with CORView Lite Element Manager Software and/or CHP Max Craft Management
Software
■ Serial cable
■ Screwdriver
■ Serrated needlenose pliers (PAD insertion and removal)
Computer Requirements
■ 64MB RAM
■ 50MB free hard drive space
■ 300MHz processor
■ Windows
®
98 2nd edition, NT 4.0, 2000 SP1, or XP Professional operating system
For optimal display, set preferences to 600 x 800 display resolution with 16-bit color
depth.
CORView Lite Element Manager Software
The ARRIS CORView Lite Element Manager Software is a distributed client/server application
designed to address the management needs of ARRIS optical and RF network access
products in your HFC network. It supports ARRIS CHP Max family of products providing
complete fault and configuration management functions.
1. For CENELEC compliance, install a FAIR-RITE snap-on toroid EMI suppression filter (FAIR-RITE P/N
0431164951 or ARRIS P/N 862344) supplied with the SMM on the cable connected to the Ethernet
connector at the rear of the chassis. This filter should be installed as close as possible to the Ethernet
connector to reduce conducted RFI.
Table 1.2 Terminal Emulation Setup Parameters
Parameter Setting
Baud Rate 38400bps (RS-232)
9600bps (SMM-2 USB)
Data 8 bit
Parity None
Stop 1
Hardware Control None
To Next Page
Loading...
Need help?
General
