Rev D CHP Max5000 Chassis (Front Fiber Version) 3-19
the CHP modules, refer to Installation of CHP Max5000 Craft Management Software on page 5-6
for instructions on installing this software. For instructions on configuring for local access to
the CHP, refer to the section To configure CHP for local access via Craft software on page 7-14.
For instructions on configuring for remote access to the CHP, refer to the section To configure
CHP for remote access via Craft software on page 7-15.
After launching the CHP Max Craft Management Software, click on the Disconnected button or
click Communication > Connect and then double-click on any of the eight fans on the rear
of the chassis. The Status and Setting window of the chassis fan bay is displayed in
Figure 3.10.
Figure 3.10
Chassis Fan Bay
Status and Settings
Management
Window
Table 3.6 Controls and Functions of the Craft Management Software
Control Function
Status and Settings tab
Window resulting from right clicking
on Fan 1 current through Fan 8
To Next Page
Loading...
Need help?
General
