Atlas Copco FlexiROC T30 R User Manual

FlexiROC T30 R 5 Transport
103 No: 2969809547.1.2969824267 en-US
G Carrier
5.5.1 Towing Crawler
Before the machine can be towed, the traction gear on both track frames must be disen-
gaged.
Precondition
p
The track frames must be clean and free of all dirt and mud before the transmission
cover plate is removed.
1.
Remove the four countersunk screws from the cover plate (B).
2.
Screw two 80 mm M8 screws into the threaded holes in the transmission cover plate
(B). Screw the screws in evenly so that the transmission cover plate (B) is pressed
away from the transmission.
3.
Remove the cover plate (B), O-ring (D), and cylinder barrel (E).
4.
Screw an 80 mm M8 screw into the thread in the center of the gear shaft (C).
5.
Use the screw head to pull out the gear shaft.
6.
Remove and check the condition of the O-ring (D). If it is damaged or worn, replace it
with a new O-ring.

Atlas Copco FlexiROC T30 R Specifications

General

Brand	Atlas Copco
Model	FlexiROC T30 R
Category	Construction Equipment
Language	English