Atlas Copco FlexiROC T30 R User Manual

FlexiROC T30 R 3 Controls and Instrument
52 No: 2969809547.1.2969824267 en-US
No Display Heater
3.5.22 Replacing Remote Control
Use the learn link routine for replacing the remote control. Learn link connects transmitter
(rig) with receiver (remote control). After the procedure the rig addresses to the new re-
mote control.
1.
Switch off the control system on the rig.
2.
Remove the end resistor on the CAN BUS coil, which is located at the aim device
(D569).
3.
Connect the learn link cable between the radio box and the CAN BUS coil.
4.
Start the control system on the rig.
5.
Start the remote control in learn-link mode by pressing button
and simulta-
neously until the "Start learn-link" view is shown on the display.
6.
Press Enter to start Learn Link.

Atlas Copco FlexiROC T30 R Specifications

General

Brand	Atlas Copco
Model	FlexiROC T30 R
Category	Construction Equipment
Language	English