FlexiROC T30 R 4 Operation
79 No: 2969809547.1.2969824267 en-US
12.
Apply hard grip by moving the right-hand multi-function lever to sector (C).
13.
Fully unthread the shank adapter from the drill rods. Right-hand multi-function lever
sector (H).
14.
Reposition the drill rods in the carousel by moving the left-hand multi-function lever to
sector (A)
4.4.3 Setting Up for Drilling
WARNING
Tipping Risk
The tipping over of a machine can cause serious injury or death.
u Keep the feeder in tramming position and the boom inside the limits of the crawler
tracks.
u Keep the track oscillation cylinders locked.
u Never exceed the maximum allowed inclination angles for the machine.
u Never combine inclination angles for downward/upward/lateral tramming.
u Note the value of the gradient meter.
u Never operate the machine from the down side.
u Ensure that unauthorized personnel are outside of the working area.
u Always check the ground conditions where the machine is operated.
CAUTION
Overloading Feeder
Overloading the feeder can cause personal injury.
u Do not use the cylinder alone for lowering the boom, or the cylinder for feed extension
individually to place the feeder against the ground.
u Do not raise the front section of the track frame from the ground
1.
Make sure that the mode switch (B) is in tramming position
(3).
To Next Page
Need help?
General
