Atlas Copco FlexiROC T30 R User Manual

FlexiROC T30 R 4 Operation
82 No: 2969809547.1.2969824267 en-US
8.
Open the rod grippers by turning and moving the left multi-function lever to section
(A).
4.4.5 Drilling Hole
1.
Set the mode switch (B) in drilling position
. The compressor is loaded automati-
cally.
2.
Check that the track oscillation cylinders are locked. Touch button
.
3.
Check that the dust collector is activated. When flushing air is activated later, the dust
collector suction starts (R).
4.
Lower the rock drill until the drill bit is pressing lightly against the ground. Right multi-
function lever (E), position (1).
5.
Reset hole depth (P) (option).
6.
Lower the suction hood to the ground switch (Q), position (3).
7.
Start rotation and flushing air. Right multi-function lever (5) to left-hand sector (D).
Hold in approximately 1 second to obtain self-holding.

Atlas Copco FlexiROC T30 R Specifications

General

Brand	Atlas Copco
Model	FlexiROC T30 R
Category	Construction Equipment
Language	English