Atlas Copco FlexiROC T30 R User Manual

FlexiROC T30 R 8 Options
133 No: 2969809547.1.2969824267 en-US
8.4.1 Preparing for Assembly ROC-ANGIE
1.
Set the feed in a vertical position with the aid of a spirit level. Adjust forward and rear-
ward for a precise vertical reading.
2.
Adjust left and right for a precise vertical reading.
3.
Check that both left and right angles and forward and rearward angles are still verti-
cal.
8.4.2 Assembling ROC-ANGIE
Precondition
p
The feed must be in a precisely vertical position, both left and right angles and forward
and rearward angles. See the "assembly" section.
1.
Attach the retaining yoke or bracket or welded beam on the feeder at such a height
that the receiver is easy to read. Attach ROC-ANGIE on the same side as the opera-
tor.
2.
Position ROC-ANGIE in the retaining yoke and tighten the bolts. Both scales show 0º
even if ROC-ANGIE is rotated round its own axis if everything is correct. Proceed to
the "adjustment" section if not.
8.4.3 Adjusting ROC-ANGIE to Zero Reading
!
NOTE: Perform a final check by rotating ROC-ANGIE around its own axis while ob-
serving the two scales - they must show 0º in all directions

Atlas Copco FlexiROC T30 R Specifications

General

Brand	Atlas Copco
Model	FlexiROC T30 R
Category	Construction Equipment
Language	English