FlexiROC T30 R 4 Operation
92 No: 2969809547.1.2969824267 en-US
11.
Open the drill rod supports with circuit breakers (M) and (N).
4.4.15 Unthreading and Extracting
WARNING
Accidental Operation
Accidental operation can cause serious injury or damage property.
u The operator must have a clear line of sight when working with a remotely operated
machine.
u Before operating the machine, always check that the controls are correctly adjusted.
u Always deactivate the remote control when not in use.
u Never stand on the machine during operation.
!
NOTE: The rod handling claws open automatically when rotating the carousel.
Precondition
p
The joints must be broken loose.
1.
Move switch (S) to position (1) to activate the rapid-feed stop.
2.
Move switches (M) and (N) to position (3) to open both drill rod supports.
3.
Move right multi-function lever (E) in position (C) to move the rock drill back. Extract
the drill string until the rock drill stops automatically with the sleeve in the upper drill
rod support.
4.
Move switch (M) to position (1) to close the upper drill rod support.
5.
Move left multi-function lever (A) to sector (E) to open the rod handling claws.
To Next Page
Loading...
Need help?
General
