Atlas Copco FlexiROC T30 R User Manual

FlexiROC T30 R 3 Controls and Instrument
53 No: 2969809547.1.2969824267 en-US
è
Now the transfer of data starts. The transfer is complete when the following im-
age is shown on the display:
7.
Switch off the remote control with the emergency stop.
8.
Switch off the rig control system.
9.
Remove the cable and put the end stop on the CAN BUS coil.
è
Now the rig is ready to restart.
3.5.23 Using Cable to Remote Control
If the communication between the machine and the remote control ceases to work or if the
remote control is not permitted by local regulations then a cable can be connected for oper-
ating the machine. The cable can also be used for the remote control when its battery is
discharged.
To use the cable to the remote control proceed as follows:
n Connect the cable between the remote control and the radio receiver on the machine.

Atlas Copco FlexiROC T30 R Specifications

General

Brand	Atlas Copco
Model	FlexiROC T30 R
Category	Construction Equipment
Language	English