AudioCodes Mediant 800C SBC User Manual

5. Connecting Device to Power
Mediant 800C with ZPLS
- 6 -
5 Connecting Device to Power
The device is powered from a standard alternating current (AC) electrical wall outlet.
Warning (Grounding)
The device must always be grounded (earthed). Grounding should be done in accordance
with the safety and electrical regulations enforced in the country of installation.
To connect device to power:
1. Ground the device, by connecting an electrically earthed strap of 16-AWG wire (minimum) to
the device's grounding screw (located on the rear panel), using the supplied washer and
fasten the wire securely using a 6-32 UNC screw. Connect the other end of the strap to
protective earthing.
2. Connect the device to power by plugging the AC power cord (supplied) into the device's AC
power inlet, located on the rear panel. Connect the plug at the other end of the AC power
cord to a standard AC electrical wall outlet.
3. Check that the device is receiving power (POWER LED on front panel should be on - green).
Figure 3: Connecting AudioCodes Mediant 800C device to the power

AudioCodes Mediant 800C SBC Specifications

General

Brand	AudioCodes
Model	Mediant 800C SBC
Category	Gateway
Language	English