Autronica AutroVoice miniVES Series User Manual

107
12.4 Priority Manager Conguration
Each zone microphone, reman microphone or audio input available in the system must have its priority dened in order to ensure
correct operation, as intended for sound emergency systems.
21.
1
Message priority mode in case of conict – FIFO / LIFO
Priority Resolve Mode  this is a global system function which denes the system’s behaviour in case a conict occurs.
Theconict being a simultaneous transmission to the speaker zone from two or more audio sources of the same priority.
For FIFO (First in rst out)  in the case when Source 1 of Priority X is transmitting to Output Y and after some time Source 2
of Priority X wants to transmit to Output Y too, Source 2 can not transmit until Source 1 has nished transmitting to Output Y.
For LIFO (Last in rst out)  in the case when Source 1 of Priority X is transmitting on Output Y (speaker zone) and, after some
time, Source 2 of Priority X will start transmitting on Output Y (speaker zone) too, then Source 2 will replace Source 1, as
transmitting, and will commence transmitting to Output Y.
Priority Resolve Mode also determines the method of dynamic assignment of a backup power amplier in case a failure
occurs of the amplier modules which are responsible for transmission of simultaneous messages of the same priorities.
Incase two equally prioritized messages are executed to various zones, Message 1 of Priority (100), Message 2 of Priority (100)
too, which was matriced after Message 1 – when an amplier module failure occurs for the FIFO mode: the amplier which
supplies Message 1 will not be taken over by Message 2 until Message 1 (matrix) has been completed; for LIFO – theMessage
1 amplier module will be disconnected and assigned as a backup amplier for Message 2.

Autronica AutroVoice miniVES Series Specifications

General

Brand	Autronica
Model	AutroVoice miniVES Series
Category	Security System
Language	English