EasyManuals Logo
Home>Autronica>Security System>AutroVoice miniVES Series

Autronica AutroVoice miniVES Series User Manual

Autronica AutroVoice miniVES Series
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
32
COMPACT VOICE ALARM SYSTEM
SERVICE MANUAL
Table 3. Technical parameters of ABT xNET_mini 1Gb/WAN/RS communication card
Model ABT xNET_mini 1Gb/WAN/RS
Source of power Control Unit main backplane
Power consumption
48V about 100mA;
Input / output / PoE extension – max. consumption 360mA,
Typical consumption depends on devices connected to the card
via RJ45 connector (PoE) max. 15W
Optical module – type of connector
SFP low power consumption modules, SC/LC connector,
Multi-mode or single-mode optical ber,
E 30 or E 90,
OM1, OM2, OM3
Number of logical inputs / outputs
2 independent channels; galvanically separated
1x NO, 1xNC output
Source of parametric input signal
Passive, standard resistors: 4k  10kΩ, detection thresholds
0/1/short-circuit/open-circuit set in conguration application
Type of logic input / output seats Screw terminals PHOENIX 6 pin-type, 3,5 mm
PoE output voltage, load capacity 48V, 0,3A of load capacity
Number of RS485 connectors 1 in RJ45
Max. length of RS485 cable 1200m (according to specications and characteristics RS485)
Working temperature 0°C to +60°C
Ambient humidity during operation from 15% to 80% (without condensation)
Storage temperature -20°C to +70°C
Ambient humidity during storage from 15% to 80% (without condensation)
Dimensions 70 x 160 x 30 (mm)
6.1.2.2 ABT-xNet_mini-1Gb communication card
The ABT-xNet_mini-1Gb is a downsized version of the previous ABT-xNet_mini-1Gb/WAN/RS communication card. As its
predecessor it consists of two independent 1 Gbit network switches.
The network switch no.1 is intended solely to transmit data related to basic AutroVoice miniVES system functions, that is perform-
ing tasks of alarm voice system and AVB support.
The network switch no. 2 is intended for remote connections. The card supports TCP/UDP/PTP/DHCP protocols and assures audio
data exchange in CPU-OFF mode via an innovative Autronica protocol. This card is not equipped with an RS485port but supports
PoE technology on one of the RJ45 ports to power e.g. reman microphone.
Unlike the AutoVoice MULTIVES system in the AutroVoice miniVES devices the communication card also doubles as the main CPU
card. It is responsible for reproducing audio messages from the SD card and sharing them locally or globally while also performing
system and control functions.
The card is capable of reproducing 8 messages at a time and supports SD cards up to 32 GB for individual messages, as well
asevent or defect logs or system update les.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Autronica AutroVoice miniVES Series and is the answer not in the manual?

Autronica AutroVoice miniVES Series Specifications

General IconGeneral
BrandAutronica
ModelAutroVoice miniVES Series
CategorySecurity System
LanguageEnglish

Related product manuals