Autronica AutroVoice miniVES Series User Manual

109
12.5 Group Zone Conguration
This function is available only from the advanced congurator level – Basic Conguration – Conguration Mode – Advanced.
Itisused to combine any predened speaker lines / zones into one. A group created in this way has the same functionalities in
the system as a single zone.
In order to create a new group, the following must be done:
1
Using the icon, a new group is created whose generic name is ZoneGroup0000x; the name is editable by moving the
mouse cursor over it and pressing the left mouse button.
2
From the Group and Areas tab, the column on the right hand side of the screen, move the mouse cursor over available
Subzones, Zones and add elements to the group by double-clicking of the left mouse button.
3
It is also possible to add all available subzones and zones by means of the dedicated icon .
4
Group cloning function: Clone Group – this is available under the icon . Highlight the previously created group by
moving the mouse cursor over its name and by clicking the left mouse button once. Then select the icon . Clone group
results in creating a new group of the identical composition as the source group.
5
Group element graphic view: Preview Group – this is available from the icon . This function presents, in a graphic form,
in one table, all groups which have been created, as well as their members.

Autronica AutroVoice miniVES Series Specifications

General

Brand	Autronica
Model	AutroVoice miniVES Series
Category	Security System
Language	English