HL-2030/2040/2070N SERVICE MANUAL
Confidential
2-27
6. NETWORK FUNCTIONS (FOR HL-2070N)
6.1 LED Functions
Fig. 2-34
No light:
If both of the two LEDs are off, then the print server is not connected to the network.
Link LED is orange:
This Link LED will be orange if the print server is connected to a 100BaseTX Fast Ethernet
network.
Link LED is green:
This Link LED will be green if the print server is connected to a 10 Base T Ethernet.
Active LED is yellow:
The Active LED will blink if the print server is receiving or transmitting data.
6.2 Network Factory Default Setting (For HL-2070N)
If you wish to reset the print server back to its default factory settings (resetting all information
such as the password and IP address information), please follow these steps;
(1) Turn off the printer.
(2) Make sure that the front cover is closed and the power cord is plugged in.
(3) All LEDs light up, and keep the Go button pressed down until the Ready LED goes off.
Release the Go button. Then the Toner, Drum and Paper LEDs go off.
(4) Press the Go button six times. Make sure that all the LEDs light up to indicate the printer
server has been reset to its default factory settings.
NOTE:
• If you wish to reset the printer and automatically disable the APIPA protocol, follow steps (1)
to (3) above. Press the Go button seven times and make sure that all the LEDs light up to
indicate the printer server has been reset to its default factory settings.
• For more information on APIPA, see the Network User’s Guide or visit
http://solutions.brother.com
• You can also disable the APIPA protocol using EWS, BRAdmin Professional or Web
BRAdmin.
LED
(Light-emitting Diode)
To Next Page
Loading...
Need help?
General
