HL-2030/2040/2070N SERVICE MANUAL
Confidential
3-25
2.2.4 Paper eject
After the printing image on the exposure drum is transferred onto the paper, the paper is fed
to the fixing unit to fix unfixed toner onto the paper by the heat roller and the pressure roller in
the fixing unit.
Afterwards, the paper is ejected from the fixing unit. The paper eject actuator detects whether
the paper is ejected correctly or not.
After the paper exits from the heat roller, the paper is turned by the rear cover and ejected
face down into the top output tray through the eject roller ASSY.
Fig. 3-31
2.3 Drum Unit
2.3.1 Exposure drum
Generates the latent electrostatic image and develops the image on the drum surface.
2.3.2 Primary charger
Forms a uniform charge on the drum surface.
(1) Corona wire
Generates the ion charge on the drum.
(2) Grid
Spreads the ion charge evenly over the drum surface.
2.3.3 Transfer roller
Transfers the toner image to the paper from the drum surface.
2.3.4 Cleaner
Removes the paper dust or dirt on the surface of the exposure drum.
Paper eject actuator
Eject roller ASSY
Rear cover
Heat roller
Pressure Roller
To Next Page
Loading...
Need help?
General
