CHAPTER 2 INSTALLATION AND BASIC OPERATION
Confidential
2-28
6.3 Network Factory Default Setting with APIPA Protocol Disabled (For HL-2070N)
If you wish to reset the print server back to its default settings with APIPA protocol disabled,
please follow these steps.
(1) Turn off the printer.
(2) Make sure that the front cover is closed and the power code is plugged in.
(3) Hold down the Go button as you turn on the power switch. All LEDs light up, and keep the
Go button pressed down until the Ready LED goes off. Release the Go button. Make
sure that the Toner, Drum and Paper LEDs are off.
(4) Press the Go button seven times. Make sure that all the LEDs light up to indicate the print
server has been reset to its default factory settings.
NOTE:
• You can disable the APIPA protocol using Web browser, BRAdmin Professional or Web
BRAdmin.
• For more information of APIPA, please refer to the Network User’s Guide.
To Next Page
Loading...
Need help?
General
