GE SNPX Protocol – PLC Error Code Tables (cont’d)
PLC Errors for GE SNPX Protocol (Minor-Major) (cont’d)
Panel Error Code
P499 Hex Value
Description
0xE005 Service in process cannot login.
0xE105 No I/O configuration to read or delete.
0xE205 IOS could not delete configuration, or bad type.
0xE305 CPU revision number does not match.
0xE405 Memory Type for this selector does not exist.
0xE505 DOS file area not formatted.
0xE605 CPU model number does not match.
0xE705 Configuration is not valid.
0xE805 No user memory is available to allocate.
0xE905 Memory Type selector not valid in context.
0xEA05 Not logged in to process service request.
0xEB05 Task unable to be deleted.
0xEC05 Task unable to be created.
0xED05 VME bus error encountered.
0xEE05 Could not return block sizes.
0xEF05 Programmer is already attached.
0xF005 Request only valid in stop mode.
0xF105 Request only valid from programmer.
0xF205 Invalid program cannot log in.
0xF305 I/O configuration mismatch.
0xF405 Invalid input parameter in request.
0xF505 Invalid password.
0xF605 Invalid sweep state to set.
0xF705 Required to log in to a task for service.
0xF805 Invalid Task Name referenced.
0xF905 Task address out of range.
0xFA05 Cannot replace I/O module.
0xFB05 Cannot clear I/O configuration.
0xFC05 I/O configuration is invalid.
0xFD05 Unable to perform auto configuration.
0xFE05 No privilege for attempted operation.
0xFF05 Service Request Error has been aborted.
EA1-MG6-USER-M Hardware User Manual, 1st Ed. Rev C, 09/10
To Next Page
Loading...
Need help?
General