Omron FINS Protocol – PLC Error Code Table (cont’d)
(PLC generated error codes for the Omron FINS protocol continued on the next page.)
PLC Error Codes for Omron FINS
Panel Error Code
P499 Hex Value
Description
0x1104 Parameter Error: Address range exceeded.
0x1106 Parameter Error: Program Missing.
0x1109 Parameter Error: Relational Error.
0x110A Parameter Error: Duplicate Data Access.
0x110B Parameter Error: Response too long.
0x110C Parameter Error: Parameter Error.
0x2002 Read Not Possible: Protected.
0x2003 Read Not Possible: Table missing.
0x2004 Read Not Possible: Data missing.
0x2005 Read Not Possible: Program missing.
0x2006 Read Not Possible: File missing.
0x2007 Read Not Possible: Data mismatch.
0x2101 Write Not Possible: Read Only.
0x2102 Write Not Possible: Protected - cannot write data link table.
0x2103 Write Not Possible: Cannot register.
0x2105 Write Not Possible: Program missing.
0x2106 Write Not Possible: File missing.
0x2107 Write Not Possible: File name already exists.
0x2108 Write Not Possible: Cannot change.
0x2201 Not executable in current mode: Not possible during execution.
0x2202 Not executable in current mode: Not possible while running.
0x2203 Not executable in current mode: Wrong PLC mode (Program).
0x2204 Not executable in current mode: Wrong PLC mode (Debug).
0x2205 Not executable in current mode: Wrong PLC mode (Monitor).
0x2206 Not executable in current mode: Wrong PLC mode (Run).
0x2207 Not executable in current mode: Specified node not polling node.
0x2208 Not executable in current mode: Step cannot be executed.
0x2301 No such device: File device missing.
0x2302 No such device: Missing memory.
0x2303 No such device: Clock missing.
0x2401 Cannot Start/Stop: Table missing.
0x2502 Unit Error: Memory Error.
0x2503 Unit Error: I/O setting Error.
0x2504 Unit Error: Too many I/O points.
0x2505 Unit Error: CPU bus error.
0x2506 Unit Error: I/O Duplication.
EA1-MG6-USER-M Hardware User Manual, 1st Ed. Rev C, 09/10
To Next Page
Loading...
Need help?
General