Canon imagePROGRAF iPF6300S Basic Guide No.1 User Manual

Cause Corrective Action
When you have loaded paper, the
paper you have loaded does not
match the type selected on the
Control Panel.
Be sure to select the correct type of paper in the Control Panel menu when load-
ing paper.
(See "Loading Rolls in the Printer.") →P.784
(See "Loading Sheets in the Feed Slot.") →P.809
The edges of the paper are dirty
Cause Corrective Action
The Platen has become dirty after
borderless printing or printing on
small paper.
Open the Top Cover and clean the Platen.
(See "Cleaning Inside the Top Cover.") →P.998
The type of paper as specified on
the printer does not match the type
specified in the printer driver.
Make sure the same type of paper is specified on the printer as in the printer
driver.
(See "Changing the Type of Paper.") →P.787
Make sure the same paper type is specified in the printer driver as on the printer.
1. Press the Stop button and stop printing.
2. Change the type of paper in the printer driver and try printing again.
The paper is wrinkled or warped. Straighten out the wrinkles or curls and reload the paper. Do not use paper that
has been printed on previously.
(See "Loading Rolls in the Printer.") →P.784
(See "Loading Sheets in the Feed Slot.") →P.809
A cut line is printed because Cut-
DustReduct. is On in the Control
Panel menu to reduce cutting dust.
If this function is not needed, set CutDustReduct. to Off in the Control Panel
menu.
(See "Menu Settings.") →P.914
The Printhead is set too low in the
Control Panel menu.
In the Control Panel menu, set Head Height to Automatic.
(See "Troubleshooting Paper Abrasion and Blurry Images (Head Height).")
→P.831
You are printing on heavyweight
paper or paper that curls or wrinkles
easily after absorbing ink.
When printing on Heavyweight Coated Paper or other paper-based media,
choose a VacuumStrngth setting of Strong or Strongest in the Control Panel
menu. If rubbing still occurs, in the Control Panel menu, use a higher Head
Height setting.
(See "Adjusting the Vacuum Strength (VacuumStrngth).")
→P.842
(See "Troubleshooting Paper Abrasion and Blurry Images (Head Height).")
→P.831
When printing on CAD Tracing Paper or other film-based media, choose a Vac-
uumStrngth setting of Standard, Strong, or Strongest in the Control Panel
menu. If rubbing still occurs, in the Control Panel menu, use a higher Head
Height setting.
(See "Adjusting the Vacuum Strength (VacuumStrngth).")
→P.842
(See "Troubleshooting Paper Abrasion and Blurry Images (Head Height).")
→P.831
The Ejection Guide is soiled. Clean the Ejection Guide.
(See "Cleaning the Printer Exterior.") →P.998
Troubleshooting > Problems with the printing quality >
The edges of the paper are dirty iPF6300S
12
1028

Canon imagePROGRAF iPF6300S Basic Guide No.1 Specifications

General

Brand	Canon
Model	imagePROGRAF iPF6300S Basic Guide No.1
Category	Printer
Language	English