Paper Detailed Settings Dialog Box
In the Paper Detailed Settings dialog box, you can set Drying Time for the paper selected with Media Type of the Main
sheet, etc.
You can display this dialog box by clicking Settings of Media Type on the Main sheet. (Refer to "Main Sheet
→P.215 ".)
As for the items for which you can selectPrinter Default in this dialog box, you also can set them from the control panel of
the printer. (Refer to "Menu Settings →P.914 ".)
A Drying Time
Specify the time that the printer waits for ink to dry, as needed. The Drying Time setting is only valid for rolls.
•
B Between Pages
You can set the time to wait after printing 1 document page until ejecting the paper. Since waiting time is required for
ink to dry before a roll is cut, you can deliver paper in the Output Stacker with the ink dried even if Cutting Mode is
set to Automatic.
Setting Item Details
Printer Default The setting of the control panel of the printer is applied.
Off Paper is ejected immediately after printing completes.
30 sec. / 1 min. / 3 min. / 5 min. /
10 min. / 30 min. / 60 min.
Paper is ejected when the set time elapses after printing completes.
•
C Between Scans
You can set the time to wait after printing 1 line on a page until printing the next line. Set this to avoid bleeding or
color unevenness such as when bleeding occurs on a page or when color unevenness occurs during borderless printing.
Setting Item
Details
Printer Default The setting of the control panel of the printer is applied.
Off The next line is printed immediately after a line is printed.
1 sec. / 3 sec. / 5 sec. / 7 sec. / 9
sec.
The next line is printed when the set time elapses after a line is printed.
* Increase the time according to the occurrence condition of bleeding or unevenness.
Windows Software
>
Printer Driver
>
Paper Detailed Settings Dialog Box iPF6300S
3
220
To Next Page
Loading...
Need help?
General