6. Press â–² or â–¼ to select Adjust Length, and then press the OK button.
7. Press â–² or â–¼ to select AdjustmentPrint or Change Settings, and then press the OK button.
When you select AdjustmentPrint, a test pattern is printed for you to measure the scale and calculate the discrepan-
cy. The scale bar shows Millimeter in 50 mm units and Inch in 1 inch units.
Note
• A test pattern is printed in black when you choose A:High or in magenta if you choose B:Standard/
Draft.
• To cancel printing the test pattern for adjustment, hold down the Stop button. When "Stop print-
ing?" is displayed, press â–² or â–¼ to select "Yes", and then press the OK button.
8. Press â–² or â–¼ to enter the amount of discrepancy, and then press the OK button.
If the scale is shorter than the actual size, use a positive setting value. If it is longer, use a negative value.
The feed amount can be adjusted in 0.02% increments.
Adjusting Color on the Trailing Edge of Sheets
If printed sheets are affected by banding in different colors by the trailing edge (about 20–30 mm (0.8–1.2 in) from the
edge), try adjusting the feed amount of the trailing edge of sheets.
Important
• This adjustment is only possible when feeding paper from the Top Paper Feed Slot that can be set up with a
margin on the trailing edge of 3 mm (0.12 in). Paper that does not allow a margin of 3 mm on the trailing
edge is automatically ejected, and the adjustment is not available.
Note
• We recommend using the type of paper you use most often for adjustment.
• For banding in different colors over the entire printed area of sheets or rolls (not only at the trailing edge of
sheets), try adjusting the overall feed amount. (See "Automatic Banding Adjustment (Adj. Quality).")
→P.834
Items to Prepare
Sheets One sheet of unused paper of at least A4/Letter size
Perform adjustment as follows.
1. Load the paper.
• Loading Sheets in the Feed Slot →P.809
Adjustments for Better Print Quality
>
Adjusting the feed amount
>
Adjusting Color on the Trailing Edge of Sheets iPF6300S
7
840
To Next Page
Loading...
Need help?
General