Pausing Printing
Pausing Printing ................................................................................................................................................ 19
Pausing Printing
During printing, if you set Pause Print in the Control Panel menu to On, printing is stopped at that point and the printer
enters a state in which printing is paused. (See "Control Panel Display.") →P.892
Printing from the job queue is not possible in this state.
To restore normal operation after this state, set Pause Print to Off.
Note
• In the following cases, the status is cleared even if you do not set Pause Print to Off, and printing from the
job queue resumes.
• When paper is advanced
• When you execute Chg. Paper Type in the Paper Menu
1. During printing, on the Tab Selection screen of the Control Panel, press â—€ or â–¶ to select the Job tab ( ).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2. Press the OK button.
The Job Menu is displayed.
3. Press â–² or â–¼ to select Pause Print, and then press the OK button.
4. Press â–² or â–¼ to select On or Off, and then press the OK button.
Basic Printing Workflow
>
Pausing Printing
>
iPF6300S Pausing Printing
1
19
To Next Page
Loading...
Need help?
General